代碼 701747: End of paper filter

There is probably no more fleece in the paperband filter. Sensor "Paperband filter available" for monitoring the amount of filter has responded. The PLC input signal "Paperband filter present" is not present. The error has the following effect as soon as the end of the machining program has been reached: Feed Stop No axis movements possible. "Spindle Stop" Tool spindle is stopped. Speed no longer possible. The 1st coolant pump, the 2nd coolant pump and the bed rinsing are then turned off. For MT series: Channel-specific "Read-in stop" after pulling bar call ( M450 ) or workpiece counting pulse ( M60 ) on this channel. The other channel, respectively, continues to run until the next tool change or rapid feed ( G0 ). The 1st coolant pump, the 2nd coolant pump and the bed rinsing are then turned off. 1. Check filter paper quantity. 2. Check the setting of the sensor "Paperband filter available" and the PLC input signal. 3. As soon as the malfunction is remedied, press one of the following keys: [FEED START] [CYCLE START] Message is cleared and the machining program can be continued.