代码 702342: 5th axis not released

Function "Unclamp 5th axis clamping" was output, but the axis clamping is not yet unclamped or signals that it is still clamped PLC input signal "5th axis clamping unclamped" is not registered, or "5th axis clamping clamped" is still registered. Feed Stop Read disable If the signal is OK again within a certain monitoring time, the machine continues to run again immediately. After the monitoring time has elapsed, the machine stops. 1. Check the PLC input signals "5th axis clamping unclamped", "5th axis clamping clamped" and the pressure sensors. 2. Check the PLC output signals "Unclamp 5th axis clamping", "Clamp 5th axis clamping" and the valves. 3. As soon as the malfunction is remedied, press one of the following keys: [FEED START] [CYCLE START] [RESET] Message is cleared. Error messages 600509 and 600609 were allocated to 702333 and 702341 starting in 01/2006. In the case of old SW versions, however, these are still displayed.