代码 SYST-223: Image backup failed(0x%x)

Cause: Image backup failed. Remedy: 0x%x shows the cause of the failure. Find the definition in the list below. Remove the cause of the failure and try the backup again. z 0x%x Cause and remedy 0x1 This isn't used. 0x2 Memory allocation failed. Call your local FANUC representative. z 0x3 Information in FROM cannot be acquired. Call your local FANUC representative. z 0x4 Make sure there is enough free space on the MC. Make sure a FLASH ATA card is inserted in the MC card slot. z 0x5 Controller could not open FROM***.IMG. Destination device might be broken. z 0x6 Controller could not read FROM. FROM module or main board FROM might be broken. z 0x7 Controller could not write data to FROM***.IMG. Destination device might be broken. z 0x8 Controller could not close FROM***.IMG. The following are possible causes: z There are already backup files on the destination device and they are write-protected. z MC was removed during backup. z Communication was disconnected during backup to TFTP server. z TFTP server is not running. z 0x9 Make sure there is enough free space on MC. Make sure FLASH ATA card is inserted to MC card slot. z 0xa Controller cannot open SRAM***.IMG. Destination device might be broken. z 0xb Controller could not write data to SRAM***.IMG. Destination device might be broken. z 0xc Controller could not close SRAM***.IMG. The following are possible causes: z There are already backup files on the destination device and they are write-protected. z MC was removed during backup. z Communication was disconnected during backup to TFTP server. z TFTP server is not running. z 0xd File for internal use may be broken. Try the backup again. z 0xe File for internal use may be broken. Try the backup again. z 0xf After power was cycled by image backup function, a backup file was found on the MC. This happens if power is turned off during automatic image backup. Retry backup from file screen again. z 0x20 Initialization of network failed. Confirm wiring and BOOTP server is running.