コード M01-1120: SP equivalent load factor over

Details The equivalent load factor of the spindle motor has exc eeded the set threshold that causes the excess warning. Remedy  Change the operation pattern in a way that decreases the spindle motor load. Differential tap cmnd disabled 1131 Details  Differential speed tap command has been given alth ough any rotation command has not been input to the reference spindle that is under spindle superimposition control.  Synchronous tap command has been given to the refer ence spindle that is under spindle superimposition control. Remedy  Cancel the synchronous tapping cycle. Spd clamp in differential tap 1132 Details  A tap cycle or synchronous tap cycl e command given to the superimpo sed spindle has caused the spin- dle's actual rotation speed to exceed the spindle clamp speed. Remedy  Correct the spindle rotation speed in synchronous tap cycle. Constant surface spd disabled 1133 Details  A constant surface speed control command has been gi ven to the reference or superimposed spindle during differential speed tapping under spindle superimposition control.  A differential speed tapping command has been issued while constant surface sp eed control is executed on the reference or superimposed spindle that is under spindle superimposition control. Remedy  Cancel the synchronous tap cycle or constant surface speed control. Spindle sync cancel error 1135 Details  Spindle synchronization cancel command has been issued during rotation of C axis under spindle sync C axis control.  G113 (without the address H or D) has been issued during the spindle synchronization for two or more sync sets. Remedy  This operation error is cancelled when C axis st ops. Issue a spindle sync cancel command after C axis has stopped.  Use G113D or G113H to cancel the spindle synchronization. GB SP sync:Cancel sgnl illegal 1137 Details The guide bushing spindle synchronization temporary cancel signal was turned ON/OFF when the master spin- dle and the guide bushing spindle were in one of the following modes.  During rotation (when not stopped)  During tap cycle syn chronization mode  During spindle synchronization mode  During tool-spindle synchronization I (polygon machining) mode  During tool-spindle synchronization II (hobbing) mode  During spindle C axis control C axis mode  During orientation/indexing Remedy  Check the ladder program. GB SP sync runs independently 1138 Details  The reference spindle was commanded as a spindle related to tool spindle synchronization IC (polygon).  The guide bushing spindle was commanded as a synchronous tapping spindle.  The guide bushing spindle was commanded as a spindle related to spindle synchronization/tool spindle synchronization I (polygon)/tool spindle synchronizati on II (hobbing). Remedy  Check the program.