代码 F00051: Parameter EEPROM Fault

Reaction: OFF 2 Acknowledge: Quit fault eg. via DI2 Cause: Read or write failure while access to EEPROM. This can also be caused by the EEPROM being full, too many parameters have been changed. Remedy: - Must be Power Cycled to cancel this bug as some parameters may not be read correct. - Factory Reset and new parameterization, if power cycle does not remove fault - Change inverter control unit - Change some parameters back to default values if the EEPROM is full, then power cycle Note: - r0949 = 1: EEPROM Full - r0949 = 1000 + Block No: Reading data block failed - r0949 = 2000 + Block No: Reading data block timeout - r0949 = 3000 + Block No: Reading data block CRC failed - r0949 = 4000 + Block No: Wrinting data block failed - r0949 = 5000 + Block No: Writing data block timeout - r0949 = 6000 + Block No: writing data block verify failed - r0949 = 7000 + Block No: Reading data block at wrong time - r0949 = 8000 + Block No: writing data block at wrong time - r0949 = 9000 + Block No: Factory Reset did not work becuase restart or power failure