代码 F00395: Acceptance Test / Confirmation pending

Reaction: OFF 2 Acknowledge: Quit fault eg. via DI2 Cause: This fault occurs after a Powermodul (PM) / Control Unit (CU) Swap or a Startup Clone. It can also be caused by a faulty read from the EEPROM, see F0051 for more details. The parameterset after a CU swap or a startup clone could have changed and might not match the application. This parameterset needs to be checked before the drive can start a motor. - r0949 = 3 / 4: Swap of PM/CU - r0949 = 5: Startup Clone via MMC has been performed - r0949 = 10: Before the last power up an acceptance test was pending due to a swap or a startup clone. Remedy: Safety Units: An Acceptance Test needs to be performed. Follow the the steps of the Acceptance Log which is part of the Oper- ating Instructions. After performing the acceptance test the fault can be acknowledged by the following procedure: P0010 = 30 P9761 = Safety password P7844 = 0 The fault will be cleared automatically and P0010 will be set back to 0 Non Safety Units: The current parameterset needs to be checked and confirmed by clearing the fault or setting P7844 = 0.