Código 10601: [Channel %1: ] Block %2 zero veloci ty at block end point during thread cutting

Parameters: %1 = Channel number %2 = Block number, label Definitions: This alarm occurs only when several blocks with G 33 follow in succession. The block end velocity in the specified block is zero, although a further thread cutting block follows. The reasons for this can be, for instance: - G9 - Auxiliary function after motion - Auxiliary function output before th e motion of the following block - Positioning axis in the block Reaction: Interpreter stop NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: Modify the NC part program by removing any programmed "Stop at end of block" G09. Modify general MD11110 $MN_AUXFU_GROUP_SPEC [n] for selecting the output time of an auxiliary function group by changing "Aux iliary function output before/afte r the movement" to "Auxiliary function output during the movement". Bit 5 = 1: Auxiliary function output before movement Bit 6 = 1: Auxiliary function output during movement Bit 7 = 1: Auxiliary function output after movement Program Continuation: Clear alarm with the RESET key. Restart part program