Código 10620: [Channel %1: ] Block %3 axis %2 at software limit switch %4

Parameters: %1 = Channel number %2 = Axis name, spindle number %3 = Block number, label %4 = String Definitions: During the traversing motion, the system detected that the software limit switch would be traversed in the direction indicated. Exceeding the traversi ng range was not detected during block preparation because there has either been a motion overlay or a zero offset has been executed or a coordinate transformation is active. Reaction: Local alarm reaction. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm at block end. Remedy: Depending on the reason for this alarm being triggered, the following remedial measures should be undertaken: - Handwheel override: Cancel the motion overlay and avoid this or keep it smaller when the program is repeated. - Transformation: Check the preset/programmed zero offsets (current frame). If the values are correct, the tool holder (fixture) must be moved in order to avoid triggering the same alarm when the program is repeated, which would again cause the program to be aborted. Program Continuation: Clear alarm with the RESET key. Restart part program