代码 14769: [Channel %1: ] Block %2 Spindle %3 Implicit auxiliary function %4 Buffer full

Parameters: %1 = Channel number %2 = Block number, label %3 = Spindle number %4 = Auxiliary function number Definitions: A maximum of 5 auxiliary functions of type "M" may be entered in an NC block. The upper limit is the total of programmed and implicitely generated M auxilia ry functions. Implicit auxiliary functions M19 and M70 are generated, if in MD35035 $MA_SPIND_FUNCTION_MASK, bit 19 has been set for M19 and/or bit 20 for M70. M19 is generated with SPOS and SPOSA depending on the configuration. The same applies to M70 and transition into axis oper ation. The address extension corresponds to the spindle number like it is output to the PLC. Reaction: Correction block is reorganized. Interface signals are set. Alarm display. Remedy: - Distribute the M auxiliary func tions and spindle functions that implicitely generate M19 and M70 to several blocks. - Deactivate any implicit auxiliary f unctions that are not required in MD35035 $MA_SPIND_FUNCTION_MASK, bit 19 and/or bit 20. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program. Diagnostics Manual (DAsl), 03/2009