Código 17831: [Channel %1: ] JOG a circle is not possible, reason %2

Parameters: %1 = Channel number %2 = Cause Definitions: The JOG in circles was activated, but this is not possible because: 1. The current positions of the axes invo lved lie outside the selected pitch circle. 2. The current positions of the axes involved, with pitch circle selected and tool radius offset active, are too near to the center of the circle. 3. The current positions of the axes involved, with t ool radius offset active, are too near to the limiting circle during internal machining. 4. The current positions of the axes involved, with t ool radius offset active, are too near to the limiting circle during external machining. 5. The current positions of the axes involved in internal machining are outside the defined circle. 6. The current positions of the axes involved in external machining are inside the defined circle. 10. A rotation is acting on the current plane, that is the current plane is inclined in space. This is not currently supported. Reaction: Interface signals are set. Alarm display. Remedy: Define axis as geometry axis. Program Continuation: Clear alarm with the Delete key or NC START.