代碼 201360: <location>Topology: Actual topology is illegal

Message value: Fault cause: %1, preliminary component number: %2 Drive object: All objects Reaction: NONE Acknowledge: IMMEDIATELY Cause: The detected actual topol ogy is not permissible. Fault value (r0949, interpret hexadecimal): ccccbbaa hex: cccc = preliminary co mponent number, aa = fault cause aa = 01 hex = 1 dec: Too many components were detected at the Contro l Unit. The maximum permissible number of components is 199. aa = 02 hex = 2 dec: The component type of a component is not known. aa = 03 hex = 3 dec: The combination of ALM and BLM is not permitted. aa = 04 hex = 4 dec: The combination of ALM and SLM is not permitted. aa = 05 hex = 5 dec: The combination of BLM and SLM is not permitted. aa = 06 hex = 6 dec: A CX32 was not directly connected to a permitted Control Unit. SINAMICS-Alarms Diagnostics Manual (DAsl), 03/2009 aa = 07 hex = 7 dec: An NX10 or NX15 was not directly connected to a permitted Control Unit. aa = 08 hex = 8 dec: A component was connected to a Control Unit that is not permitted for this purpose. aa = 0A hex = 10 dec: Too many components of a certain type detected. aa = 0B hex = 11 dec: Too many components of a certai n type detected at a single line. Note: The drive system is no longer booted. In this stat e, the drive control (closed-loop) cannot be enabled. Remedy: Re fault cause = 1: Change the configuration. Connect less than 199 components to the Control Unit. Re fault cause = 2: Remove the component with unknown component type. Re fault cause = 3, 4, 5: Establish a valid combination. Re fault cause = 6, 7: Connect the expansion module directly to a permitted Control Unit. Re fault cause = 8: Remove component. Re fault cause = 10, 11: Reduce the number of components.