代码 22022: [Channel %1: ] Block %2 spindle %3 gear stage %4 is expected for axis mode.

Parameters: %1 = Channel number %2 = Block number, label %3 = Spindle %4 = Gear stage Diagnostics Manual (DAsl), 03/2009 Definitions: The gear stage required for axis mode has not been installed. A gear stage has been configured in MR35014 $MA_GEAR_STEP_USED_IN_AXISMODE, in which the spindle is to be in axis mode. This gear stage is checked whenever the spindle is switched into axis mode. The configured gear stage is compared with the gear stage output by the PLC (NC/PLC interface signal DB31,... DBX16.0. -.2 (Actual gear stage A through C)). This alarm will be output if the gear stages are not the same. Reaction: Interface signals are set. Alarm display. Remedy: Program M70 before the switch to axis mode. The gear stage configured in MD35014 $MA_GEAR_STEP_USED_IN_AXISMOD E is then automatically loaded. No gear stage change is required if the configured gear stage is aleady active. M40 remains active beyond the gear stage change. Consider MD20094 $MC_SPIND_RIGID_TAPPING_M_NR. Program Continuation: Clear alarm with the Delete key or NC START.