Código 22033: [Channel %1: ] Block %2 Axis/spindle %3 'Correct synchronism' diagnostics %4

Parameters: %1 = Channel number %2 = Block number, label %3 = Axis/spindle number %4 = Diagnostics Definitions: The following situation occurred during 'Correct synchronism': - Diagnosis 1: An exis ting override motion is terminated on key reset. - Diagnosis 2: The ove rride motion has been deleted. - Diagnosis 3: Writing of override value not allowed. Synchronism override is deleted. - Diagnosis 4: Override motion is stopped tem porarily (e.g. G74 reference point approach) - Diagnosis 5: Delay of override motion: a cceleration capacity used up by other motions. - Diagnosis 6: Delay of override motion: velocity used up by other motions. - Diagnosis 7: Delay of override motion: the maximum speed is limited to 0. System variable $AC_SMAXVELO_INFO[n] shows the reason for this. - Diagnosis 8: Delay of override motion: the ma ximum acceleration capac ity is limited to 0. $AC_SMAXACC_INFO[n] shows the reason for this. MD11411 $MN_ENABLE_ALARM_MASK activates this alarm: - Bit 9 = 1 for diagnosis 1 to 6 - Bit 12 = 1 for diagnosis 7 to 8 Reaction: Alarm display. Remedy: Deactivate the alarm with MD 11411 $MN_ENABLE_ALARM_MASK Bit9 = 0 or Bit12 = 0. Program Continuation: Clear alarm with the Delete key or NC START.