代碼 22070: [TO unit %1: ] Please change tool %2 into magazine. Repeat data backup

Parameters: %1 = TO unit %2 = T number of tool Definitions: The alarm can only occur when the tool management f unction is active in the NCK. (TOOLMAN = tool management) A data backup of the tool/magazine data has been started. During the backup, the system detected that tools are still located in the buffer magazine (= spindle, gripper,...). During the backup, these tools will lose the information whic h defines the magazine and location to which they are allocated. It is therefore practical -assuming that the data are to be stored exactly as before - to ensure that all tools have been deposited in the magazine before the data backup!! If this is not the case, some m agazine locations will hav e the 'reserved' status when the data are loaded again. This 'reserved' stat us must then be reset manually. For tools with fixed location coding, the loss of the information allocating their location in the magazine has the same effect as a general empty locati on search when they are returned to the magazine. Reaction: Interface signals are set. Alarm display. Remedy: Ensure that no tools are located in the buffer magazine before the data backup. Repeat the data backup after removing the tools from the buffer magazine. Program Continuation: Clear alarm with the Delete key or NC START.