代码 4036: Wrong NCU link configuration by MD %1

Parameters: %1 = String: MD identifier Definitions: Occurs only with an NCU link system. Different interpolation and position control cycles have been set in the NCUs of the LINK group. This is only allowed if the function FAST-IPO-LINK in MD18780 $MN_MM_NCU_LINK_MASK has been activated. Caution: For diagnostic purposes, two additional alarm parameters are output together with this alarm. - 1. 2nd parameter: Position control or IPO cycle time of this NCU - 2. 2nd parameter: Position control or IPO cycle time of another NCU. Diagnostics Manual (DAsl), 03/2009 Reaction: NC not ready. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Remedy: - Activate FAST-IPO-LINK function inMD18780 $MN_MM_NCU_LINK_MASK - Or do not set different position control or IPO cycles on the NCUs (see MD10070 $MN_IPO_SYSCLOCK_TIME_RATIO and MD10060 $MN_POSCTRL_SYSCLOCK_TIME_RATIO). Program Continuation: Switch control OFF - ON.