代碼 4040: [Channel %1: ] Axis identifier %2 not consistent with machine data %3

Parameters: %1 = Channel number %2 = String: Axis identifier %3 = String: MD identifier %4 = There are not enough channel axes entered in the MD displayed. Definitions: The use of the specified axis identifier in the displa yed MD is not consistent the channel's axis configuration stated in the MD20070 $MC_AXCONF_MACHAX_USED and MD20050 $MC_AXCONF_GEOAX_ASSIGN_TAB. Only with active "OEM transformation" compile cycle: There are not enough channel axes entered in the MD displayed. Reaction: NC not ready. Mode group not ready, also effective for single axes NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Remedy: Please inform the authorized personnel/service department. Check and correct the identifier used in the MD10000 $MN_AXCONF_MACHAX_NAME_TAB, MD20080 $MC_AXCONF_CHANAX_NAME_TAB and/or MD20060 $MC_AXCONF_GEOAX_NAME_TAB. Only with active "OEM transformat ion" compile cycle: In addition to the specified MD, check and correct MD24110 $MC_TRAFO_AXES_IN_1[n] of the acti vated OEM transformation according to the function description. Program Continuation: Switch control OFF - ON.