代碼 4050: NC code identifier %1 cannot be reconfigured to %2

Parameters: %1 = String: Old identifier %2 = String: New identifier Definitions: Renaming of an NC code was not possible for one of the following reasons: - The old identifier does not exist - The new identifier lies in another type range. NC codes/keywords can be reconfigured via machine data as long as the type range is not abandoned. Type 1: "real" G codes: G02, G17, G33, G64,... Type 2: named G codes: ASPLINE, BRISK, TRANS,... Type 3: settable addresses: X, Y, A1, A2, I, J, K, ALF, MEAS,... Reaction: NC not ready. Mode group not ready, also effective for single axes NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Remedy: Please inform the authorized personnel/service department. Correct MD10712 $MN_NC_USER_CODE_CONF_NAME_TAB (protection level 1). The list must be built up as follows: Even address: Identifier to be modified. Following odd address: New identifier e.g.: $MN_NC_USER_CODE_CONF_NAME_TAB [10] = "ROT" $MN_NC_USER_CODE_CONF_NAME_TAB [11] = " " clears the ROT function from the control Program Continuation: Switch control OFF - ON.