代码 4065: Buffered memory was restored from backup medium (potential loss of data!)

Definitions: Only occurs with SINUMERIK 840D / 840Di sl / 802D. !! 840Di sl only The user data of the NC and the remanent data of the PLC are stored in the static memory area (SRAM) of the MCI board. The content of the SRAM is backed up as an SRAM image on PCU hard disk at each "NCK POWER ON reset" and each time Windows XP is closed down normally. The previously valid SRAM image then becomes the SRAM backup, which is also stored on the PCU hard disk. The SRAM backup is used and alarm 4065 issued in the following cases: HW serial no SRAM MCI board SRAM image MCI board "OK" "OK" 1. Known No No 2. Unknown Yes No 3. Unknown No No !! Only for 802D The reason for this alarm is that the backup time is exceeded. Make sure that the required operating time of the control corresponds to the specifications in your Installation & Start-up Guide. The current backup copy of the buffered memory has been created by the last internal data backup via the "Save data" softkey on the HMI. Reaction: NC not ready. NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: Make a POWER ON reset. !! 840Di / 840Di sl only: Alarm 4065 also has to be acknowledged on the HMI after a POWER ON reset: HMI: Operating area switchover > Diagnostics > NC/PLC Diagnostics > Diagnostics > "Acknowledge alarm 4065" button Note Press the "ETC" key to change to the secondary softkey bar in order to acknowledge the alarm with a softkey. Program Continuation: Switch control OFF - ON.