代碼 6425: [Channel %1: ] Tool %2 cannot be placed in magazine %3 on location %4. Invalid definition of magazine!

Parameters: %1 = Channel ID %2 = String (identifier) %3 = Magazine number %4 = Magazine location number Definitions: The desired tool motion command - triggered from t he MMC or PLC - is not possible. A movement request was issued to put the tool in a location wh ich does not satisfy the prerequisites for filling. The following causes for the error are possible: - Location is blocked or not free! - Tool type does not match the location type! - Tool possibly too large, adj acent locations are not free! - If a tool is to be loaded or unloaded, the lo ad/unload position must be of 'load location' type. - If a tool is to be loaded or unloaded, is the magazine in question linked to the load/unload location? See $TC_MDP1, $TC_MDP2. Reaction: NC Start disable in this channel. Interface signals are set. Alarm display. Diagnostics Manual (DAsl), 03/2009 Remedy: - Check whether the magazine data have been defined correctly. - Check whether there is still room in the magaz ine to add another tool; there may not be due to operating procedures. - Check whether a location type hierarchy is defined and whether it, for example, does not allow insertion of a type 'A' tool in a free location with type 'B'. - Check whether the magazine in question is linked to the load/unload location or whether a distance has been defined. - Check whether the load/unload pos ition is of 'load location' type. See also $TC_MPP1. Program Continuation: Clear alarm with the Delete key or NC START.