代码 10758: [Channel %1: ] Block %2 curvature radius with variable compensation value too small

Parameters: %1 = Channel number %2 = Block number, label Definitions: The current cutter radius compensation (the cutter us ed) is too large for the programmed path radius. In a block with variable tool radius compensatio n, a compensation must be possible either anywhere or nowhere on the contour with the smallest and the largest compensation value from the programmed range. There must be no point on the contour in whic h the curvature radius is within the variable compensation range. If the compensation value varies its sign within a bl ock, both sides of the contour are checked, otherwise only the compensation side. Reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end. Remedy: Use smaller cutters or allow for a part of the cu tter radius at the time of contour programming. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.