代码 10759: [Channel %1: ] Block %2 path is parallel to tool orientation

Parameters: %1 = Channel number %2 = Block number, label Definitions: In a block with spline or polynomial interpolation, the corrected path runs in at least one point parallel to the tool orientation, i.e. the path has a tangent perpendicular to the compensation plane. The tangent at a point on a path is regarded as parall el to the tool orientation if the angle between the two directions is less than the limit value defined by MD21080 $MC_CUTCOM_PARALLEL_ORI_LIMIT. However, in circumferential milling, straight lines running parallel to the tool orientation are permissible, as well as circles with a circle plane per pendicular to the compensation plane (application with smooth retraction from the groove). Straight lines in the direction of the tool orient ation are not permissible in face milling (CUT3D, CUT3DF, CUT3DFS). Reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end. Remedy: Do not use splines or polynomials when writing the contour section, but straight lines and circles instead. Divide up the tool piece geometry and dese lect the cutter radius compensation between the various sections. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.