代碼 201708: <location>SI Motion CU: STOP C initiated

Message value: Drive object: SERVO, VECTOR Reaction: STOP2 Acknowledge: IMMEDIATELY (POWER ON) Cause: The drive is stopped via STOP C (braki ng along the OFF3 deceleration ramp). "Safe Operating Stop" (SOS) is activated after the parameterized timer has expired. Possible causes: - stop request from the higher-level control. - subsequent response to the message C01714 "SI Motion: Safely reduced speed exceeded". - subsequent response to the message C01715 "SI Motion: Safe end stop exceeded". See also: p9552 (SI Motion transition time STOP C to SOS (SBH) (Control Unit)) Remedy: - remove the cause of the fault at the control. - carry out a diagnostics routine for message C01714. This message can be acknowledged as follows: - motion monitoring functions integrated in the driv e: Via Terminal Module 54F (TM54F) or PROFIsafe - motion monitoring functions with SI NUMERIK: Via the machine control panel Note: SI: Safety Integrated SOS: Safe Operating Stop / SBH: Safe operating stop